Filter
Top Products
36 © 1999 Directed Electronics, Inc. Vista, CA
■ The Valet
®
switch doesn’t work.
Is it plugged into the correct socket? (See Plug-In Harnesses section of this guide.)
Check the System Features Learn Routine for the programmed Valet
®
pulse count. (See System Features Learn
Routine section of this guide.)
■ Status LED doesn’t work.
Make sure that it is plugged in. (See Plug-In Harnesses section of this guide.) Is the LED plugged into the correct
socket?
■ Cannot access the Transmitter/Receiver Learn Routine through the Valet switch:
Is the Valet switch plugged into the correct socket? (See Plug-In Harnesses section of this guide.)
The system may be programmed for Transmitter Lockout. This feature can only be toggled on or off by using a
DEI Bitwriter or PC interface module (DEI part number 996T).
■ Cannot access the System Features Learn Routine through the Valet switch:
Is the Valet switch plugged into the correct socket? (See Plug-In Harnesses section of this guide.)
Are the door inputs connected?
Is the YELLOW H1/9 wire connected to the primary ignition wire of the vehicle?
The system may be programmed for Feature Lockout, which can only be toggled on or off by using a DEI Bitwriter
or PC interface module (DEI part number 996T).