Filter
Top Products
© 1999 Directed Electronics, Inc. Vista, CA 33
4. Press the transmitter button: While holding the Valet
®
/Program button, press the button
from the transmitter that you wish to assign to that channel. The unit will chirp indicat-
ing successful programming. It is not possible to teach a transmitter button to the system
more than once.
Channel 1 AUTO-LEARN: Programming to Channel One will automatically configure the channels in the
standard configuration. (Refer to owner’s guide, standard configuration)
Channel 2: If any transmitter button from a known transmitter is programmed to Channel Two, all transmitters
will be erased from memory, and system features will return to factory default settings. This is useful in cases
where one of the customer’s transmitters is lost or stolen. This will erase any lost or stolen transmitters from the
system’s memory. It can also be used to start from scratch if the transmitter buttons were programmed incor-
rectly.
Channel 7-9: To configure the system’s remote transmitters for OEM mode, Channels Seven through Nine are used
to assign the arm, disarm, and panic functions to separate buttons on the remote control. If the remote trans-
mitter being used has already been programmed to the system it will be necessary to delete all transmitters (see
Channel Two) before that transmitter can be programmed to Channels Seven through Nine.
CHANNEL NUMBER FUNCTION WIRE COLOR
1 Auto learn
2 Delete all transmitters
3 Arm/Disarm/Panic
4 Channel Two Red/White
5 Channel Three White/Blue
6 Channel Four Violet/Black
7 Arm
8 Disarm
9 Panic