Filter
Top Products
18 © 1999 Directed Electronics, Inc. Vista, CA
Connect this wire to the (+)12V ignition wire. This wire must show (+)12V with the key in Run position and during
cranking. Take care to insure that this wire cannot be shorted to the chassis at any point.
Connect this to the red wire of the siren. Connect the black wire of the siren to (-) chassis ground, preferably at
the same point you connect the control module’s black ground wire.
Before connecting this wire, remove the supplied fuse. Connect to the battery positive terminal or the constant 12V supply
to the ignition switch.
NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 15A fuse
in the harness for this purpose. This fuse protects the module itself.
When the system receives the code controlling Channel Two for longer than 1.5 seconds, the red/white will supply
an output as long as the transmission continues. This is often used to operate a trunk/hatch release or other
relay/driven function.
H1/12 RED/WHITE 200 mA (-) channel 2 output
H1/11 RED (+) 12V constant power input
H1/10 BROWN (+) siren output
H1/9 YELLOW (+) ignition input