Filter
Top Products
© 1999 Directed Electronics, Inc. Vista, CA 15
This wire provides a 200 mA (-) output whenever the transmitter button(s) controlling channel three is pressed.
This output can be programmed to provide the following type of outputs (see System Features Learn Routine
section of this guide):
■ A validity output will send a signal as long as the transmission is received.
■ A latched output will send a signal continuously when channel three is pressed and will continue until
channel three is pressed again.
■ A latched/reset with ignition output works similar to the latched output, but will also reset (output will
stop) when the ignition is turned on then off.
■ A 30-second timed output will send a signal for 30 seconds when channel three is pressed. This output can
also be programmed to provide a second unlock pulse when the disarm button is pressed within 15 second
after disarming the system. This can be used to unlock the passenger doors when installing progressive door
locks.
■ A second unlock output will provide a second unlock pulse whenever the disarm button is pressed within 15
seconds after disarming the system. This setting could be used to unlock the passenger doors when installing
progressive door locks, for instance.
■ A delayed accessory output provides a 200mA (-) latched output three seconds after the ignition is turned
on. It will remain active when the key is turned off, until a door is opened and closed. This setting could be
used in conjunction with a relay to energize certain circuits in the vehicle that would normally require the
key to be turned on i.e. the radio, power windows, etc.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! This
transistorized output can only supply (-)200 mA, and connecting directly to a solenoid, motor, or
other high-current device will cause the module to fail.
H1/3 WHITE/BLUE 200 mA (-) channel three output