Filter
Top Products
RS1000 OP 1/07
17
P. DRIVER PAGING / LOST & FOUND
This feature is useful in the event that someone wants to page the driver of the parked vehicle or you
cannot find his OLED remote transceiver.
Indoor Driving Paging
If the ignition switch is in the “off” position, press and hold the valet switch for 2
seconds to page the driver. One chirp sound shall be emitted from the vehicle and the
paging melody will sound from your Remote OLED transceiver. “DRIVER PAGING”
indication will flash on the OLED screen.
Outdoor Driving Paging (optional)
If someone tries to page you by tapping the paging (knock) sensor, the paging melody will sound on your
Remote OLED transceiver and “DRIVER PAGING” indication will flash on the OLED screen. The knock
sensor is usually located on the driver’s side of the front windshield.
1. Spin up the switch to the page 4 and then press the “Driver Pager” button. It will respond with chirps
from the vehicle. A melody sound and “DRIVER PAGING” indication flashes on the OLED screen to
confirm the function has been turned ON.
2. When tapping the paging (knock) sensor on the vehicle, one chirp sound will be emitted and the paging
melody will sound from you Remote OLED transceiver. The “DRIVER PAGING” indication will flash on
the OLED screen.
3. Turning ON the ignition switch or pressing the
button or button will exit the driver paging mode.
Q. DOME LIGHT CONVENIENCE DELAY & SUPERVISION
The alarm has a unique feature, which will turn on your vehicle’s dome light as follows:
1. Upon disarming, the interior light will remain on for 30 seconds.
2. If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turning ON the ignition switch or arming the alarm will turn off the dome light.
R. IGNITION CONTROL DOOR LOCK/UNLOCK.
If the vehicles power door locks have been interfaced to the security system, the system will automatically
lock the vehicle's doors in 3 seconds when the ignition is turned “ON” and /or unlock the vehicle’s doors
when the ignition is turned “OFF”. (Programmable)
S. TRUNK RELEASE (CHANNEL 3) OUTPUT.
Press and hold button on the transmitter for three seconds to remotely control the
trunk release or other electric devices.
T. CHANNEL 4/5/6 TIMER CONTROL OUTPUT
Activate The Channel 4: Spin up the switch to the page 3 and then press the “Channel 4” button or
press the transmitter
and buttons at the same time to active Channel 4 function.
Activate The Channel 5: Spin up the
switch to the page 3 and then press the “Channel 5” button or
press the transmitter
and buttons at the same time to active Channel 5 function.
Activate The Channel 6: Spin up the
switch to the page 3 and then press the “Channel 6” button or
press the transmitter
and buttons at the same time to active Channel 6 function.
U. MULTI- VEHICLE SECURITY OPREATION:
Your remote transmitter can be utilized to control multi- vehicle security system, to program the remote
control transmitter to a second vehicle, follow the instructions for Transmitter programming. All
programming parameters will be the same except for the following:
For Regular Remote Control Transmitter:
1. Prior to pushing any button on the transmitter. Press the Select
II button first on the transmitter.
2. Once
II button is pressed the LED on the transmitter will illuminate for 3.5 seconds to indicate the
second transmitter pin code is ON.
3. While the LED is illuminated, press any button on the remote control transmitter to control a second
vehicle security system.