Filter
Top Products
RS1000 OP 1/07
16
Here’s how the “Noise Abatement Circuit” works: If the alarm triggers five times, each time the same
sensor (zone 4) is triggered the “Noise Abatement Circuit” will interpret this pattern of triggers as false
alarms. After the fifth trigger, the “Noise Abatement Circuit” ignores, or bypasses that sensor until any
other sensor or switch is triggered.
“Noise Abatement Circuit” covers doors (Hood/Trunk) differently: If the alarm is triggered by an open door
for six full cycles, the doors will be bypassed until the trigger ceases.
M. ANTI CAR- JACKING (Programmable)
Warning: If you do not need the car jacking function in this alarm system, be sure to set the car jacking
feature “OFF”. This systems default setting is car-jacking feature “OFF”.
ACTIVE ANTI CAR JACKING:
1. Spin up the
switch to the page 1 and then press and hold the “Car Jacking”
button for 2 seconds or press and hold the transmitter
and buttons at the
same time for 2 seconds while the vehicle’s ignition is ON. The parking lights will
turn on for 1.5 seconds to indicate the system has entered the car-jacking mode.
2. Once the system is in car-jacking mode and you are forced from the vehicle, the
system will be triggered when the door is opened and closed while the ignition is in
the “ON” position.
PASSIVE ANTI CAR- JACKING:
(Programmable)
1. Turn the ignition switch to the “ON” position. The system enters the car-jacking
mode.
2. Once the system is in car-jacking mode and you are forced from the vehicle, the
system will trigger when the door is opened and closed while the ignition is in the
“ON” position.
TRIGGER SEQUENCE OF THE ANTI CAR - JACKING MODE:
a). 50 seconds after the system has beer triggered. The siren will start chirping for 15 seconds.
b). During this 15 second period of chirping, you will be alerted to push the valet switch once to turn off
the car-jacking feature. If not, it will enter the second timer of the car jacking sequence.
c). 65 seconds after the system has beer triggered the siren starts alarming and the parking lights will
start flashing.
d). 90 seconds after the system has beer triggered
1. The siren will still be alarming and the parking lights will continue flashing.
2. The starter disable will activate to prevent the vehicle from starting if stopped.
3. It will remain active until the vehicle's battery power is exhausted.
OVERRIDE THE SYSTEM TO TURN OFF ANTI CAR- JACKING:
Turn the ignition switch from OFF to ON and within 10 seconds push valet switch, the siren will stop and
the system will be disarmed
*Note: If you use password pin code to double protect the vehicle security, you will need to use it to
completely disarm the system.
N. SYSTEM’S TRIGGER CHECK
Spin up the switch to the page 4 and then press the “Trigger
Check” button. The remote will respond with one melody sound
and all trigger records will immediately be displayed on the OLED
screen.
Note: It will display the homepage if there were no system’s
triggered.
O. SYSTEM’S STATUS CHECK
Spin up the switch to the page 4 and then press the “Status
Check” button. The remote will respond with one melody sound
and the vehicles status will immediately be displayed on the OLED
screen.
Note: It will display the home page if the car’s status is normal.