Filter
Top Products
–
None
–
Clock
–
Date
–
Remaining travel time: The calculated remaining travel time to
arrival at the next via point or the destination.
–
Remaining dynamic travel time (where TMC is available).
–
Estimated time of arrival.
–
Estimated dynamic time of arrival (where TMC is available).
–
Entire delay on route (where TMC is available).
–
Distance to the destination.
–
Geographical hight.
–
Current speed
You can select one value for each statusline to be displayed:
u
In the ”Settings” menu, select ”Screen config”. Press OK.
u
Select the function to be set and press OK.
u
Select your choice and press OK. The cursor will automatically
return to the previous menu.
The navigation system uses an average travel speed for the calculation of
the remaining travel time and the estimated time of arrival. If necessary,
you can adjust this speed to your actual average speed using the option
”System information/Speed correction”.
Measuring units
Selection of units of measurement for displaying and announcing
distances and speeds. The following options are available:
•
Time format
•
Date format
•
Measuring units
•
Time zone
•
In the ”Settings” menu, select ”Measuring units”. Press OK.
•
Select the function to be set. Pressing OK will toggle between the
available alternatives.
•
At time zone press OK and curser keys to set the value up and
down in half hour intervals. Press OK again (time is relative to GMT).
•
Select “Return” and press OK to confirm the setting.
•
Pressing ESC or curser key will take you to the previous menu.
18
GENERAL INFORMATION