Filter
Top Products
Installation Guide
PROGRAMMING
8
PROGRAM MODE - USER SETTINGS
Enter User Program Mode - See Page 7 for details on entering program mode
1 Double Pulse Unlock 1 Flash Single .75sec.Lock pulse and double Unlock Pulse
2 3 Second Lock & Unlock 2 Flashes 3 second pulses for Lock & Unlock
*3 0.75 Second Pulses 3 Flashes 0.75 second pulses for Lock and Unlock
1 Ignition Lock & Unlock Enabled 1 Light Flash Doors Lock / Unlock when the key is turned On/ Off
2 Ignition Lock Only 2 Light Flashes Doors Lock when ignition key is turned ON only
*3 Ignition Auto Lock Disabled 3 Light Flashes Doors do not Lock or Unlock with Ignition key
1 Lock & Unlock chirps Disabled 1 Flash Honks for Panic and Car Finder Mode only.
2 Lock & Unlock chirps Enabled 2 Flashes Honks for Lock, Unlock, Panic and Car Finder Mode Only.
*3 All chirps enabled 3 Flashes Honks for Lock, Unlock, Start, Panic and Car Finder Mode.
Press the Program Switch 1 time to select setting 1 (This will be confirmed by 1 LED flash)
Press and hold the Program Switch until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Switch. Press the Program momentarily to move to next program step or repeat to change selection.
Press the Program Switch 2 times to select setting 2 (This will be confirmed by 2 LED flashes)
Press and hold the Program Switch until you receive the appropriate # of park light flashes and/or horn honks
Release the Program Switch. Press the Program momentarily to move to next program step or repeat to change selection.
Press the Program Switch 3 times to select setting 3 (This will be confirmed by 3 LED flashes)
Press and hold the Program Switch until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Switch. Press the Program momentarily to move to next program step or repeat to change selection.
Press the Program Switch 4 times to select setting 3 (This will be confirmed by 4 LED flashes)
Press and hold the Program Switch until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Switch. Press the Program momentarily to move to next program step or repeat to change
Setting 1- Ignition Auto Lock
Setting 2- Horn Honk Settings
Setting 3- Door Lock Options
Setting 4 -Sensor - Enable / Disable
1 Sensors Disabled 1 Flash Impact Sensors Disabled
* 2 Sensors Enabled 2 Flashes Impact Sensors Enabled - Normal Operation
Press the Program Switch 5 times to select setting 1 (This will be confirmed by 5 LED flashes)
Press and hold the Program Switch until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Switch. Press the Program momentarily to move to next program step or repeat to change selection.
Press the Program Switch 6 times to select setting 1 (This will be confirmed by 6 LED flashes)
Press and hold the Program Switch until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Switch. Press the Program momentarily to move to next program step or repeat to change selection.
1 Passive Arming 1 Flash System Auto Arms 30 seconds after last door is closed
2 Active Arming With Rearm 2 Flashes System Auto-Arms if unlock is pressed and no door is opened within 30sec
* 3 Active Arming 3 Flashes Alarm Arms Only with Transmitter
1 No Auto-Lock with Passive Arm 1 Flash Doors do not auto-lock with passive arming
*2 Doors Auto-Lock with Passive 2 Flashes DOORS LOCK WHEN PASSIVE ARMING
Setting 5 - Passive / Active Arming
Setting 6 - Active / Passive Locks