Filter
Top Products
Installation Guide
OPERATIONS
Manual Transmission Remote Starters must have both the door trigger and park brake wires connected. Most
installs will require a clutch bypass. This is a temporary bypass. The clutch should only be bypassed during
the activation of the remote starter. Never disconnect or alter the switch to be always bypassed. Always use a
“M” Series Remote Starter on a manual transmission vehicle.
Never install a automatic Remote Starter model into a manual transmission vehicle. It is not recommended to
install a remote starter on a convertible type vehicle. If doing so It is highly recommended that a radar sensor
is installed to cover the proximity of the gear shift lever. If the radar sensor is tripped the remote starter will exit
Reservation Mode.
To enter Reservation Mode, the following steps must be followed.
Step 1 - While the vehicle is running, place the transmission in neutral and apply the parking brake.
Step 2 - Press and release the brake pedal. The park lights will activate.
Step 3 - Turn the ignition key off and the vehicle will stay running.
Step 4 - Exit the vehicle and close the door. The vehicle will then shut off.
Step 5 - The vehicle can now be safely remote started.
Reservation Mode will automatically be exited if the doors of the vehicle
are opened. The set-up mode will then have to be repeated . Reservation Mode Must be set-up each time the
vehicle is parked.
Note: If the vehicle is not in Reservation Mode and the Start button is pressed, the system will flash
the park lights four times slowly.
NOTE: If the vehicle has a dome light delay, the vehicle may stay running until the dome light turns off. This is
normally no longer than 30 seconds.
Reservation Mode - Manual Trans.
Step 1 - Within three seconds turn the ignition Key ON-OFF-ON-OFF-ON - Leaving Key ON
Step 2 - Press and hold the Program Switch - Parking Lights will come ON **if park-lights do not come
on at this point, turn key off for 5 seconds, the repeat step 1.
Step 3 - Continue to hold the Program Switch until park lights go out.
Step 4 - Press the LOCK button on each of 1st car remotes and press the # button on each of the 2nd
car remotes of the transmitters to be programmed. The park lights will flash once and the horn
will honk once each time a new code is learned.
Note: Transmitter programming must done quickly. Do not pause more than one second between each
transmitter. All the transmitters to be used must be programmed at the same time. All transmitters
not programmed at this time will be erased from memory for security. The system holds a
maximum of 3 transmitter codes including 2nd car remote codes.
You can program the same remote as a 1st car remote in one vehicle and as a 2nd car remote in a
second vehicle.
+
-
Step #1 Step #2
Step #3 Step #4
Carefully remove the
screw from back of
the remote.
Remove top case
then replace the
battery.
Replace top case.
Re-install screw.
Test remote for
proper operation.
The transmitter battery should be changed at least once every year to maintain proper operating range.
Replace with quality23A 12volt Alkaline battery.
Transmitter Programming
Battery Replacement
12