Filter
Top Products
Installation Guide
Program mode allows you to adjust the settings and options of your system.
Menu 2 - Alarm Settings - Page 9
This program menu contains settings that adjust the way the system operates for the user.
Your system has been intelligently designed by installers with years of experience. The system’s default
settings do not require any program changes in most cases. However, this system does incorporate a highly
advanced programming system that includes 4 menus with numerous options and settings that can be easily
adjusted for custom installations and applications.
Menu 1 - User Settings - Page 8
This program menu contains settings that adjust the way the system operates for the user.
Menu 3 - Starter Settings - Page 10
This menu controls features and settings associated with remote car starter applications.
Menu 4 - Tach Settings - Page 11
This menu allows the programming of the tach signal and the manual adjustment of that setting.
Programming Overview
Entering Program Mode
Changing the Programmable Settings
To Enter Program Mode
1) Make sure ignition is in the off position.
2) Within three seconds turn the key ON - OFF - ON - OFF - ON. Leave in the “ON” position.
3) Press and release the Program Button on the antenna one time.
4) The park lights will come on and the siren will chirp to confirm entering Program Mode.
5) Select the Desired Program Menu:
Note: If unit does not enter Program Mode, turn the ignition off for five seconds and repeat steps 1-4.
** The first ignition(Blue wire) MUST be connected to the vehicle’s first ignition wire. If it is not
connected it will not be possible to enter the Program Modes.
Press Button #1 Lock User Options Page 8
Press Button #2 Unlock Alarm Option Page 9
Press Button #3 Start Remote Start Options Page 10
Press Button #4 Aux Tach Adjustment Menu Page 11
6) The selected mode will be confirmed by a siren chirp and one park light flash.
7) The Program Menu may be changed at any time by pressing the transmitter buttons as above, this
allows the installer to change a setting from one menu, then quickly jump to another menu and
change another setting without re-entering the Program Mode.
8) To exit Program Mode, Turn the ignition key “OFF” or wait 30 second and the system will exit
automatically. This will be confirmed by one long siren chirp and park light flash.
To Select and Change A Program Setting:
1) Enter Program Mode.
2) Select the desired Program Menu. (See pages 8 - 11)
3) Press & release the Program Button the correct number of times to select the desired Program
Setting(as listed on pages 8 - 11). The park lights will flash and the siren will chirp to indicate the current
setting that is selected.
4) Press and hold the Program Button until the parking lights / siren confirm the selected setting. The
park lights will flash and the siren will chirp to indicate the option selected within the setting.
5) Turn the ignition key “Off” to exit Program Mode.
NOTE: This procedure is listed in detail below each program setting on pages 8 - 11 of this manual.
PROGRAMMING
STEP 1 - Within three seconds turn the key ON-OFF-ON-OFF-ON (Leaving Key ON).
STEP 2 - Press and release the Program Button.
STEP 3 -The park Lights will turn ON.
STEP 4 - Press the Program Button a second time and hold for 8 seconds until the park lights flash
and the siren will chirps three times.
The system is now re-set to factory defaults.
NOTE: Reset to defaults does not delete the transmitters from memory.
SYSTEM RESET
7