Filter
Top Products
48-EN
Installation Setup
[Installation] is selected on the General setup menu in step 3. See
“General Setup Operation” (page 43).
Setting item: Installation
The Installation check screen is displayed.
Setting the External Audio Processor
On/Off
[External Audio Processor] is selected on the General setup menu in
step 3. Refer to
“General Setup Operation” (page 43).
When a compatible external audio processor is connected, please set
this item to “On”.
Setting item: External Audio Processor
Setting contents: Off (Initial setting) / On
• Some items of Sound Setup cannot be adjusted from this unit when
External Audio Processor is set to On.
• Press and hold
/AUDIO button is invalid when External Audio
Processor is set to On .
Setting the Digital Output
[Optical] is selected on the General setup menu in step 3. Refer to
“General Setup Operation” (page 43).
To connect an audio processor using optical digital output, set to “On”
by the following procedure.
Setting item: Optical
Setting contents: Off (Initial setting) / On
• This setting is available only when External Audio Processor is set to
On. Refer to “Setting the External Audio Processor On/Off”
(page 48).
• If Optical is set to On, the Optical ( ) indicator appears.
• ,
and MUTE buttons are invalid when Optical is set to On.
Sound Setup Operation
1
Touch [Setup] icon of Top banner.
The Setup main screen is displayed.
2
Touch [Sound].
The Sound Setup screen appears.
3
Select the desired item.
Setting items: Balance/Fader/Subwoofer*
1
/ Media Xpander*
1
/
EQ Presets
*
1
/ Parametric EQ*
1
/
Time Correction
*
1
/ X-Over*
1
/ Defeat*
1
/ Volume /
Source Volume Setup
*
2
Off: The connected audio processor is not
recognized by X008U/INE-W957HD.
On: The connected audio processor is recognized
by X008U/INE-W957HD.
Sound Setup
To display the Sound Setup Menu screen:
Your vehicle must be parked with the ignition key in the ACC or
ON position. To do this, follow the procedures below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the Sound mode operation has been
released. Engaging the parking brake can reactivate the Sound
Setup Menu, as long as the car’s ignition has not been turned off.
It is not necessary to repeat the above procedure
(1 through 3) of “To display the Sound mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the Sound mode screen.”
The following steps 1 to 5 are common operations to each
“Setting item” of Sound Setup. Refer to each section for details.