Filter
Top Products
43-EN
Touch the [SETUP] icon on the Audio/Visual Playback screen to
display the Setup main screen.
General Setup Operation
1
Touch [Setup] icon of Top banner.
The Setup main screen is displayed.
2
Touch [General].
The General Setup screen appears.
3
Select the desired item.
Setting items: iDataLink Setup / Text Display / Remote Sensor
*
1
/
Top/Bottom Banner Fade Out / Screen/
LED Customize / Visual / About / Installation /
External Audio Processor / Optical
*
2
*
1
Displayed only when Rear Seat Entertainment (RSE) is On
(page 60).
*
2
Available only when External Audio Processor is On.
• Depending on the item, repeat step 3.
4
Touch [] or [] etc., to change its setting.
• When the pop-up window for setup is displayed, touch [] to
close the window after setting.
5
Touch [] to return to the previous screen.
• Immediately after changing the settings of General Setup (While the
system is writing data automatically) do not turn the ignition key to
OFF. Otherwise, the settings may not be changed.
iDataLink Setup
[iDataLink Setup] is selected on the General setup menu in step 3. Refer
to “General Setup Operation” (page 43).
You can set whether the following source button in the top banner is
available.
Setting item: USB/iPod / SiriusXM / Bluetooth Audio
Setting contents: Both (Initial setting) / OEM / Aftermarket
Setup
Setup Operation
General Setup
To display the General Setup Menu screen:
Your vehicle must be parked with the ignition key in the ACC or
ON position. To do this, follow the procedures below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the General mode operation has
been released. Engaging the parking brake can reactivate the
General Setup Menu, as long as the car’s ignition has not been
turned off. It is not necessary to repeat the above procedure
(1 through 3) of “To display the General mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the General mode screen.”
The following steps 1 to 5 are common operations to each
“Setting item” of General Setup. Refer to each section for
details.
[SETUP] icon
Setting the Source Category
Both: Both the sources listed above from this unit
and iDataLink module are available.
OEM: Only the source listed above from iDataLink
module is available. The source from iDataLink
module is marked with .
Aftermarket: Only the source listed above from this unit is
available.