Filter
Top Products
April 1, 2006 18 Lit. No. B64090, Rev. 00
ELECTRICAL INSTALLATION – SNOWPLOW SIDE
1. Connect the red power wire from the plow harness
to the pump motor terminal stud. Hardware
provided on pump.
2. Place the 3/8 lock washer, the black ground wire
(from the harness) and the red ground wire on the
coil harness (from the manifold) over the tapped
hole on the pump and secure with 3/8"-16 x 3/4"
screw.
3. Remove the nut and washer from the POWER
HITCH™ connect/disconnect toggle switch and
insert it through the back of the mounting bracket
on the A-frame. Align the notches on the switch
and bracket. Replace the washer and nut and
tighten until the switch is firmly in place. Attach
the connector on the plow harness to the switch.
NOTE: Use caution when connecting, switches
can break if done forcefully.
4. Attach the connector on the harness to the
connector on the coil harness.
5. Position the harness braid in the notch on the
switch bracket and secure it with a cable tie.
NOTE: The diode loop harness should be inside of
the pump cover.
6. Install the pump & manifold cover by aligning the
notches in the cover with the welded bolts on the
A-frame brackets. Secure with clamping knob.
Verify the cover is positioned over the protective
toggle switch hood. Pop the front of the cover on
the threaded stud and secure it with the remaining
knob.
The Pump Cover Installs Over
The Top Of The Draw Latch
Switch Bracket