AB Soft 760HD Offroad Vehicle User Manual


 
Lit. No. B64090, Rev. 00 15 April 1, 2006
Apply
Thread-Locking
Compound
Apply
Thread-Locking
Compound
MOLDBOARD & A-FRAME ASSEMBLY
10. Secure the manifold to the A-frame. Remove the
washers, split lock washers and cap screws from
the manifold and align the mount holes with the
A-frame brackets. Properly replace and tighten all
hardware.
NOTE: A medium strength thread-locking
compound should be used to secure the manifold
mount fasteners.
11. Hook each extension spring to the receiving holes
on the pivot beam and attach the opposite end of
the spring to its respective spade bolts. Install the
spade bolts through the extension spring mounting
angle on the top rear of the blade. Secure each
spade bolt by placing one 5/8" flat washer on the
bolt and thread one 5/8"-11 nylon insert lock nut.
Tighten each lock nut until a piece of paper can
pass between the 3rd & 4th coils on the spring.
12. Install the blade guides at each end of the
moldboard. Insert the cap screw through the holes
at the top of the wing reinforcement rib. Tighten all
screws with locknuts.