VerteX RTH Series H.8 and H.16 Series
54
Open the system body and install a new disk (connect the data cable and the power cable).
Connect power to the system and boot the system.
Select {Menu} Æ {Setup} Æ {Storage} using the arrow keys and the Select button.
A newly displayed disk will then be displayed as {New}.
Select a newly installed disk using the arrow keys and the Select button and initialize the disk as a {Direct}
or a {Backup} disk. The following describes the method of setting a direct storage.
Selecting {Direct-Init} or {Backup-Init} causes all data in the device to be erased. Therefore,
caution is required.
While {Direct-Init} or {Backup-Init} is being set up, do not remove the device (may cause an
error when detecting the device).
To use the external or portable storage device for system upgrade, set to {Backup-Init} in
the {New} item for {Main Setup} {Storage Device} {Local Storage Device Management}.
When used in DVR equipment for the first time, a backup USB device will always be
detected in the {New} category. Therefore, a USB device in the {New} category must be set up
as {Backup-Init} prior to use for backup. A USB device that has gone through this procedure
will be detected in the {Backup} category when used again in the DVR equipment.
{Direct} shows the status of the newly installed disk online.
C. Operation of the local storage device
From the Manage Local Storage menu, select {Direct}, {Backup}, and {New} using the arrow keys.
If there is a valid storage device in the corresponding tab, the desired storage device may be selected
using the arrow buttons.
Select the storage using the Select button. Popup menus will then be displayed.
Select menus using the arrow keys and the Select button.
D. Direct HDD Format
Select the desired model in {Menu} Æ {Setup} Æ {Storage} and the window as shown below appears.
[Figure 5-40. Storage Offline]
Select Offline and select the model as shown below..
