SS
SS
S
tep 2tep 2
tep 2tep 2
tep 2
DD
DD
D
isconnect Sisconnect S
isconnect Sisconnect S
isconnect S
tock Btock B
tock Btock B
tock B
rake Linerake Line
rake Linerake Line
rake Line
3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 8
Loosen the hard line fitting from the stock brake
line, using an 11mm flare wrench on the hard
line fitting, while using a 14mm line wrench to
hold the stock brake line fitting.
Place a drip tray or several rags directly below
the inboard brake line connection. If the area
around the brake line connection to the chassis
is dirty, clean it using brake cleaner or an appro-
priate cleaning agent.
Remove the hard line fitting, and place one of
the rubber caps over the end of it, to control fluid
loss during the installation.
WW
WW
W
arar
arar
ar
ning: Bning: B
ning: Bning: B
ning: B
rr
rr
r
ake fluid will damage most painted surake fluid will damage most painted sur
ake fluid will damage most painted surake fluid will damage most painted sur
ake fluid will damage most painted sur
faces. Ifaces. I
faces. Ifaces. I
faces. I
mmediately clean spilled brmmediately clean spilled br
mmediately clean spilled brmmediately clean spilled br
mmediately clean spilled br
akeake
akeake
ake
fluid from any painted surface. Also be sure that the cap is securely installed on the masterfluid from any painted surface. Also be sure that the cap is securely installed on the master
fluid from any painted surface. Also be sure that the cap is securely installed on the masterfluid from any painted surface. Also be sure that the cap is securely installed on the master
fluid from any painted surface. Also be sure that the cap is securely installed on the master
cylindercylinder
cylindercylinder
cylinder
. If the cap is loose or r. If the cap is loose or r
. If the cap is loose or r. If the cap is loose or r
. If the cap is loose or r
emoemo
emoemo
emo
vv
vv
v
ed, it is likely that mored, it is likely that mor
ed, it is likely that mored, it is likely that mor
ed, it is likely that mor
e fluid will drip during bre fluid will drip during br
e fluid will drip during bre fluid will drip during br
e fluid will drip during br
akeake
akeake
ake
installation.installation.
installation.installation.
installation.
Note: Retain the rubber washers which areNote: Retain the rubber washers which are
Note: Retain the rubber washers which areNote: Retain the rubber washers which are
Note: Retain the rubber washers which are
located on either side of the hard line bracket,located on either side of the hard line bracket,
located on either side of the hard line bracket,located on either side of the hard line bracket,
located on either side of the hard line bracket,
taking care to note their orientations, and totaking care to note their orientations, and to
taking care to note their orientations, and totaking care to note their orientations, and to
taking care to note their orientations, and to
keep them properly identified, so that theykeep them properly identified, so that they
keep them properly identified, so that theykeep them properly identified, so that they
keep them properly identified, so that they
can be rcan be r
can be rcan be r
can be r
einstalled correinstalled corr
einstalled correinstalled corr
einstalled corr
ectly laterectly later
ectly laterectly later
ectly later
..
..
.
