SS
SS
S
tep 8tep 8
tep 8tep 8
tep 8
AA
AA
A
ttach Sttach S
ttach Sttach S
ttach S
tainless Stainless S
tainless Stainless S
tainless S
teel Bteel B
teel Bteel B
teel B
rake Linerake Line
rake Linerake Line
rake Line
3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 19
Check to ensure that the brake line is not bind-
ing in any way, nor interfering with any suspen-
sion component. If necessary, loosen the in-
board end of the line, and slightly re-clock the
fitting.
Use a 14mm wrench to hold the stainless line
inboard fitting, while using an 11mm flare
wrench to tighten the hard line fitting.
Reinsert the rubber washers on either side of
the inboard brake line bracket, then remove the
rubber cap from the hard line, and screw the
stainless steel brake line onto the hard line fit-
ting by hand for a few turns.
