Install the caliper onto the adapter bracket, ori-
enting it so that the bleed screws are on the top
side of the caliper.
Slide the brake pads into position in the caliper,
taking care to ensure that the friction side of each
pad is facing the rotor.
SS
SS
S
tep 7 (Conttep 7 (Cont
tep 7 (Conttep 7 (Cont
tep 7 (Cont
’’
’’
’
d.)d.)
d.)d.)
d.)
II
II
I
nstall Cnstall C
nstall Cnstall C
nstall C
aliper and Paliper and P
aliper and Paliper and P
aliper and P
adsads
adsads
ads
3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 17
(Y(Y
(Y(Y
(Y
es, thees, the
es, thees, the
es, the
yy
yy
y
’’
’’
’
vv
vv
v
e been installed backware been installed backwar
e been installed backware been installed backwar
e been installed backwar
d beford befor
d beford befor
d befor
e!)e!)
e!)e!)
e!)
Take care to ensure that the caliper is square and
evenly started on both studs. It may be necessary
to use a mallet to gently tap the caliper into posi-
tion.
Install the jet nuts onto each stud, with one 12mm
washer under each nut. Tighten the jet nuts to
40 lb-ft 40 lb-ft
40 lb-ft 40 lb-ft
40 lb-ft of torque, using a 1/2” socket.
Install the stainless steel brake line onto the cali-
per, using a 14mm wrench to tighten the line
fitting.
