Use a marking pen to trace a cutting route around
the lip of the dust shield, where the caliper bracket
mounts.
SS
SS
S
tep 4tep 4
tep 4tep 4
tep 4
RR
RR
R
emoemo
emoemo
emo
vv
vv
v
e De D
e De D
e D
ust Sust S
ust Sust S
ust S
hieldhield
hieldhield
hield
The dust shield must be permanently removed from both rear wheels of the vehicle, to accommodate
the AeroRotors. This involves cutting each shield with sheet metal snips or a power cut-off wheel, and
de-burring sharp edges with a file or power die grinder.
WW
WW
W
arar
arar
ar
ning: These operning: These oper
ning: These operning: These oper
ning: These oper
ations can be dangerations can be danger
ations can be dangerations can be danger
ations can be danger
ous, and injurous, and injur
ous, and injurous, and injur
ous, and injur
y can occury can occur
y can occury can occur
y can occur
. F. F
. F. F
. F
or anyor any
or anyor any
or any
one who is notone who is not
one who is notone who is not
one who is not
competent or comforcompetent or comfor
competent or comforcompetent or comfor
competent or comfor
table pertable per
table pertable per
table per
forfor
forfor
for
ming these operming these oper
ming these operming these oper
ming these oper
ations, Sations, S
ations, Sations, S
ations, S
topTtopT
topTtopT
topT
ech rech r
ech rech r
ech r
ecommends that theecommends that the
ecommends that theecommends that the
ecommends that the
y seek they seek the
y seek they seek the
y seek the
services of a trained professional. Safety glasses and work gloves should always be worn duringservices of a trained professional. Safety glasses and work gloves should always be worn during
services of a trained professional. Safety glasses and work gloves should always be worn duringservices of a trained professional. Safety glasses and work gloves should always be worn during
services of a trained professional. Safety glasses and work gloves should always be worn during
metal-cutting operations.metal-cutting operations.
metal-cutting operations.metal-cutting operations.
metal-cutting operations.
Cut around the entire circumference of the dust
shield, using a cut-off wheel or sheet metal snips.
Remove the dust shield, and carefully de-burr any
sharp edges, using a file or power die grinder.
Test-fit the rotor, and turn it to check that no
remaining part of the dust shield comes into con-
tact with it.
3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 10
WW
WW
W
arar
arar
ar
ning: The ABS sensor lead is located di-ning: The ABS sensor lead is located di-
ning: The ABS sensor lead is located di-ning: The ABS sensor lead is located di-
ning: The ABS sensor lead is located di-
rr
rr
r
ectly behind the dust shield. Tectly behind the dust shield. T
ectly behind the dust shield. Tectly behind the dust shield. T
ectly behind the dust shield. T
ake carake car
ake carake car
ake car
e not toe not to
e not toe not to
e not to
damage it when cutting or removing the shield.damage it when cutting or removing the shield.
damage it when cutting or removing the shield.damage it when cutting or removing the shield.
damage it when cutting or removing the shield.
