BMW E39 M5 and 5-Series Rear Axle KitBMW E39 M5 and 5-Series Rear Axle Kit
BMW E39 M5 and 5-Series Rear Axle KitBMW E39 M5 and 5-Series Rear Axle Kit
BMW E39 M5 and 5-Series Rear Axle Kit
NN
NN
N
ote: Iote: I
ote: Iote: I
ote: I
t is import is impor
t is import is impor
t is impor
tant to rtant to r
tant to rtant to r
tant to r
ead and understand this ENTIRE installation manual, including theead and understand this ENTIRE installation manual, including the
ead and understand this ENTIRE installation manual, including theead and understand this ENTIRE installation manual, including the
ead and understand this ENTIRE installation manual, including the
break-in procedures, before starting the installation.break-in procedures, before starting the installation.
break-in procedures, before starting the installation.break-in procedures, before starting the installation.
break-in procedures, before starting the installation.
Kit ContentsKit Contents
Kit ContentsKit Contents
Kit Contents
Your StopTech Big Brake kit includes the following:
1 pair of ST-40 four-piston calipers, sized specifically for your vehicle
1 set of high-performance street pads (not suitable for track use)
1 pair of 355 X 32mm two-piece rotor assemblies
1 pair of aluminum caliper adapter brackets
4 ea. 7/16-20 self-locking jet nuts
4 ea. 12mm washers
1 pair of stainless steel brake lines
2 ea. rubber end caps
TT
TT
T
ools and Eools and E
ools and Eools and E
ools and E
quipment Rquipment R
quipment Rquipment R
quipment R
equirequir
equirequir
equir
eded
eded
ed
Some different models or years of vehicle may use different sized fasteners. Every effort has been taken
to correctly identify the proper sized tool for each job. Occasionally, the manufacturer may use an
alternate fastener. Check that each tool correctly fits the fastener before loosening or tightening it.
The following tools and equipment will be needed:
16mm wrench or socket with extension (1/2” drive suggested)
14mm wrench or socket (in some cases, 9/16” may be required)
14mm flare wrench
11mm flare wrench
11mm box wrench
1/2” socket (3/8” drive suggested)
6mm Allen (hex) wrench
5mm Allen (hex) wrench
Torque wrenches capable of 10-85 lb-ft settings
Sheet metal snips or cut-off wheel, and a file or die grinder
Needle-nose pliers
Safety glasses and work gloves for the metal-cutting process
Small drip tray or several rags
Small funnel or suitable means of filling master cylinder reservoir
Anti-seize compound
Brake bleed bottle
1 pair of jack stands or other means of supporting vehicle
Plastic or non-marring mallet
DOT 3 or 4 Brake Fluid. Check manufacturer’s recommendation for compatibility. StopTech
recommends flushing brake fluid every 1-2 years, or more often under severe usage conditions. If
not done recently, the installation of a brake kit is an excellent opportunity to refresh your brake
fluid, or to upgrade to a higher-performance fluid, such as Motul 600.
3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 6
