A SERVICE OF

logo

Open as PDF
next previous
27
AC1234-6 Rev. C
Maintenance
WARNING: To prevent personal
injury,
•
Only qualied personnel may
perform inspections and
repairs to this machine.
•
Read and follow the
instructions and warnings
in this manual, and wear
protective equipment such as
goggles and gloves.
•
Do not operate the machine
when the shroud has been
removed.
General Maintenance
Wipeoffthemachineoftenusingacleanclothto
removegreaseanddirt.
Periodicallycheckhosesandconnectionsforleakage.
UseaJ2913electronicleakdetectortocheckttings
whentheunithasbeendisconnectedfromitspower
sourceandtheshroudhasbeenremoved.Ifyou
detectaleakthatyoucan’trepair,contactaRobinair
authorizedservicecenter.
Electrical Protection
Themachineisequippedwithafuselocatedinside
thefrontshroud.Trytodeterminethecauseofthe
fusefailure,suchasanincorrectpowersourceoran
extensioncordthatistoolong.
1.Disconnectthemachinefromitspowersource.
2.Removetheoildrainbottle.
3.RemovethefourscrewsshowninFigure12,and
removetheshroud.
4.Locatethefuseonthecentersheetmetal.Replace
thefusewiththesameamperageandtype.
5.Replacetheshroudandtheoilbottle.
Tank Fill Adjustment
Themaximumsettingfortankllis6.8kg(15lbs.).
Thisvaluemaybeadjustedtosuittheapplication.The
minimumvalueis1.8kg(4lbs.).
1.SelectTANK FILL ADJUSTMENTfromtheSetup
menu.
2.Themachinedisplaysthedefaultamountof
refrigerant:
TANKLEVEL
4.5KG
3.SelectOKtoacceptthedefaultamount,orusethe
keypadtoenteranamountandselectOK.
Figure 12
Remove the four screws
holding the shroud.