Traps & MIBs
C-16
6371-A2-GB20-10August 2000
Configuration MIB
The supported groups used with the DSL Configuration MIB, pdn_Config.mib,
are:
H Device Configuration Copy Group
H Trap Configuration Group
H Paradyne Device Configuration Time Group
H Traps
Table C-10. Device Configuration Copy Group Objects Table
Object
Description Setting/Contents
devConfigAreaCopy
(devConfigArea1)
Use to configure the current configuration to the
factory defaults settings.
NOTE: ALL current configuration input is
purged when the DSL router is
resets as a result of this command.
Data purged includes:
– Interface IP addresses
– IP route table entries
– ARP cache entries
– NAT entries
– DHCP server entries
H noOp (1) – always reads as this
value and represents:
factory1-to-active(8)
devConfigTrapEnable
(devConfigTrap1)
This object determines which trap types are
sent, represented by a bit map as a sum.
Allows multiple trap types to be enabled or
disabled simultaneously.
Bit positions:
H 1 – warmStart trap
H 2 – authenticationFailure trap
H 4 – enterpriseSpecific traps
H 8 – LinkUp trap
H 16 – LinkDown trap
devConfigTimeOfDay
(devConfigTime 1)
Displays the current time. —
cCN(7) Signifies a configuration change or a software
upgrade.
H 7 – Warning trap
cCNTrapEnable
(router 28)
Use to enable or disable the configuration
change trap.
H 1 – Disable trap
H 2 – Enable trap
