Traps & MIBs
C-2
6371-A2-GB20-10August 2000
DSL Router Traps
The table below lists the traps supported by the DSL router. All traps are defined
with a severity of Critical, Major, Minor, Warning, or Normal. By default, all traps
are initially disabled.
Table C-1. DSL Router Traps
Trap Event(Trap #)
Severity Description MIB Variable Binding*
authenticationFailure Minor The authenticationFailure trap
signifies an event where access
has been attempted and failed.
There are several conditions
that can cause an
Authentication Failure trap, such
as three failed attempts to login.
hot_sys.mib
(Hotwire System
MIB)
IfIndex (RFC 1573)
cCN(7) Warning The configuration has changed
via the user interface or an
SNMP Manager. The trap is
sent immediately, providing
there has been no CCN trap for
30 minutes. This suppresses the
sending of numerous traps
when multiple changes are
made in a short period of time.
hot_sys.mib
(Hotwire System
MIB)
IfIndex (RFC 1573)
deviceFailure(2) Major An internal device failure has
been detected by the operating
software for the DSL router.
hot_sys.mib
(Hotwire System
MIB)
IfIndex (RFC 1573)
devFailureStatus
(pdn_HealthAndStatus)
devSelfTestFailure(1) Minor A hardware failure of the unit
was detected as part of the
unit’s selftest. This trap is
generated after the unit has
completed initialization.
hot_xdsl.mib
(Hotwire xDSL
interface)
IfIndex (RFC 1573)
devSelfTestResults
(pdn_HealthAndStatus)
diagApplTestStart(2) Normal At least one test has been
started on an interface; e.g.,
Ping, TraceRoute.
hot_xdsl.mib
(Hotwire xDSL
interface)
IfIndex (RFC 1573)
applTestID
applTestType
diagApplTestStop(102) Normal This indicates that a test has
completed on an interface.
hot_xdsl.mib
(Hotwire xDSL
interface)
IfIndex (RFC 1573)
applTestId (pdn_diag)
applTestType (pdn_diag)
applTestStatus
LinkDown(3) Normal Informational. IfIndex
(RFC 1573)
IfIndex (RFC 1573)
LinkUp(4) Normal Informational. ifIndex
(RFC 1213)
IfIndex (RFC 1573)
WarmStart Normal The Warm Start trap signifies
that the unit has just
re-initialized itself. This trap is
sent after the unit has been
reset (either with a reset
command or the result of a
power disruption).
MIB II
(RFC 1213)
IfIndex (RFC 1573)
* All traps have the Super Overloaded ifIndex as a variable-binding (as a minimum).
