Traps & MIBs
C-15
6371-A2-GB20-10
August 2000
Health and Status MIB
Objects supported by the Health and Status MIB, pdn_HealthAndStatus.mib,
include the following groups:
H Device Health and Status
H Device Selftest Status
H Device Abort Status
H Device Failure Status
H Traps
Table C-9. Device Status Group Objects Table
Object
Description Setting/Contents
devHealthandStatus
(devStatus1)
This object displays alarm
messages if any alarms are
generated by the device.
Possible alarms are:
H Alarm: Management Address Conflict.
H Alarm: Failed Selftest.
H Alarm: System Error.
H No alarm is set.
devSelfTestResults
(devStatus 2)
This object corresponds to
self-test results. This value is
used as a binding for
devSelfTestFailure Trap.
H P – Passed selftest.
H F – Failed selftest.
devAbortStatus
(devStatus 3)
This object is used to retrieve
the latest abort status that is
stored in the agent.
Possible abort codes are:
H INVALID_INTR
H INT_TIMEOUT
H O_YAMOS_FAILURE
H INIT_NOBUFS
H SYSCALL_FAILED
H G_NO_BUF
H G_BAD_CONFIG
H G_NO_ABORT
devFailureStatus
(devStatus 4)
This object is used to retrieve
the latest failure status.
This value is used as a binding for the deviceFailure trap.
devStatusTrapEnable
(devStatus 8)
Allows user to enable or
disable the selftest failure
indication trap and the device
failure indication trap
individually.
Bit Sum.
H 1 – devSelfTest failure.
H 2 – device failure.
devStatusTestFailure Signifies that the sending
protocol’s device failed selftest.
The variable binding for this trap is the
devSelfTestResults object of the Health and Status MIB.
deviceFailure Signifies that the sending
protocol’s device failed.
The reason for the failure was not selftest.
