Traps & MIBs
C-7
6371-A2-GB20-10
August 2000
Extension to Interfaces Table (RFC 1573)
This extension contains additional objects for the Interface table. Table C-4 shows
the objects supported.
Table C-4. Extension to Interfaces Table
Object
Description Setting/Contents
ifName
(ifXEntry 1)
Provides the name of the
interface.
Specifies the interface name:
H dsl1 – DSL interface.
H eth1 – Ethernet interface.
ifHighSpeed
(ifXEntry 15)
Displays the downstream
speed for the DSL or
Ethernet interface in Mbps.
Depending on the current mode of operation, displays the speed in
1 million bits per second (Mbps) of the Ethernet interface as:
H 10 Mbps
H 100 Mbps
Due to the speed displaying as Mbps, the DSL interface downstream
speed displays as 0 (zero).
ifConnector
Present
(ifXEntry 17)
Indicates whether there is
a physical connector for
the interface.
The value for all interfaces is always:
H true(1)
IP Group (RFC 1213)
The Internet Protocol Group objects are supported by the unit for all data paths
that are currently configured to carry IP data to/from the unit. All of the objects in
the IP Group, except for the IP Address Translation table, are fully supported.
Table C-5 provides clarification for objects contained in the IP Group.
Table C-5. IP Group Objects (1 of 2)
Object
Description Setting/Contents
ipForwarding
(ip 1)
Specifies whether the unit is acting
as an IP gateway for forwarding of
datagram received by, but not
addressed to, the DSL router.
The value is read-only and always displays: (1)
ipDefaultTTL
(ip 2)
TTL = Time To Live. Minimum value – 15. Maximum value – 255.
H 64 – Default.
ipAddrTable
(ip 20)
The address table. The device sets the object ipAdEntReasmMaxSixe to
16384. Supported as read-only.
