Accessing the DSL Router
2-3
6371-A2-GB20-10
August 2000
Setting Up the New User’s Login
The DSL router will provide the login prompt when the local console connection is
first established. When the login prompt appears, a locally connected console
defaults to Console Enabled with Operator access only.
" Procedure
For first-time access to the Hotwire DSL Router’s command line interface:
1. At the initial login> prompt, type the default login ID paradyne and press
Enter.
2. At the password> prompt (for Operator), type the default password abc123
and press Enter.
The login ID and password fields are validated together.
3. At the system identity of CUSTOMER> prompt, type admin enable and press
Enter.
4. At the password> prompt (for Administrator), type the default password
abc123 and press Enter.
5. The system identity will change to the Administrator display mode of
CUSTOMER#>. Type configure terminal and press Enter.
6. The system identity will change to the Administrator configuration mode of
CUSTOMER - CONFIG#>.
7. To change the login ID, enter text to replace the default of paradyne:
name
your new login ID
NOTE:
The Login ID and Password fields are NOT case-sensitive.
8. Enter a new password and specify the level:
password
level password
Example: type password operator 238clrd3 and press Enter.
Both the Login ID and the Password fields are 1–31 printable alphanumeric
ASCII characters in the ASCII hex range of 0x21–0x7E. No spaces are
allowed. The following table lists the invalid characters.
Invalid Characters
Value ASCII Hex Translation
# Number sign 0x23
$ Dollar sign 0x24
% Percentage 0x25
& Ampersand 0x26
