5707070-A Installation and Operation 2-1
Chapter
Sono-Trak™ Doppler Ultrasonic Flow Meter
Chapter
2
Installation and Operation
BEFORE INSTALLING THE UNIT
Before installing your Sono-Trak™ Doppler ultrasonic flow meter, follow the steps
listed below:
1. See “Unpacking the Unit” on page 2-1.
2. Make sure you have performed the “Pre-installation Procedures and Checks” on
page 2-2.
3. Determine if your process/installation is compatible with the requirements of
Doppler flow meter. See “Determining if Your Process/Installation is Right for a
Doppler Flow Meter” on page 2-3).
4. Proceed to “Installation Procedures” on page 2-9.
Unpacking the Unit
Unpack and inspect the unit carefully, looking for obvious physical damage. If no
damage is apparent, locate and save all documentation and then proceed with the
following procedures.
If you see signs of shipping damage, contact EMCO product support at Advanced
Energy and the carrier immediately (see “EMCO Flow Systems Support” on
page 3-11 for contact information). Save the shipping container for submitting
necessary claims to the carrier.
INCLUDED EQUIPMENT
Table 2-1 lists the standard items that ship with Sono-Trak™ Doppler ultrasonic flow
meter systems.
