xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
98
debug bgp show flag
Purpose This command is used to display the current BGP debugging flags’ setting
Syntax
debug bgp show flag
Description This command is used to display the current BGP debugging flags’ setting
Parameters None.
Restrictions Only Administrator level users can issue this command.
Example usage:
This example shows the BGP debug flag:
DGS-3627:admin# debug bgp show flag
Command: debug bgp show flag
Current BGP flags setting:
Peer FSM Event Disable
OPEN Packet Receive Disable
OPEN Packet Send Disable
UPDATE Packet Receive Disable
UPDATE Packet Send Disable
KEEPALIVE Packet Receive Disable
KEEPALIVE Packet Send Disable
NOTIFY Packet Receive Disable
NOTIFY Packet Send Disable
REFRESH Packet Receive Disable
REFRESH Packet Send Disable
CAPABILITY Packet Receive Disable
CAPABILITY Packet Send Disable
Filter Info Disable
Route MAP Disable
Access List Disable
Prefix List Disable
ERROR Information Disable
Zebros Debug Info Disable
Other Normal Information. Disable
debug bgp all flag
Purpose This command is used to set all BGP debugging flags to be disabled or enabled
Syntax
debug bgp all flag [enable | disable]
Description This command is used to set all BGP debugging flags to be disabled or enabled
Parameters
enable - Enable the BGP debug function
disable - Disable the BGP debug function
Restrictions Only Administrator level users can issue this command.
Example usage:
Configure all BGP debug flags’ state to be enabled:
