xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
IP Standard Access List Settings
This window is used to create an access list used to filter routes.
To view this window, click L3 Features > IP Route Filter > IP Standard Access List Settings, as shown below:
Figure 4- 153. IP Standard Access List Settings window
The IP standard access list parameters are described below:
Parameter Description
Access List Name
Enter the name of the access list.
Click Apply to implement changes made. To remove an entry from the table, click its corresponding under the Delete heading.
Route Map Settings
This window is used to create a route map or add/delete sequences to a route map.
To view this window, click L3 Features > IP Route Filter > Route Map Settings, as shown below:
Figure 4- 154. Route Map Settings window
The route map parameters are described below:
Parameter Description
Route Map List
Name
Enter the route map name.
Click Apply to implement changes made. To remove an entry from the table, click its corresponding under the Delete heading.
295
