Filter
Top Products
4-21
CAUTION:
_
Always tighten the locknut against the ad-
justing nut and tighten it to the specified
torque.
_
8. Place the air filter case in the original po-
sition, connect the air intake duct, and
then tighten the clamp screw at the car-
buretor side.
9. Install the bolts, and then connect the
hose.
10. Install the seat.
Adjust the rebound damping force as follows.
Turn the rebound damping force adjusting
screw in direction
a
to increase the rebound
damping force and in direction
b
to decrease
the rebound damping force.
NOTE:
_
Make sure that the position indicator marks
are aligned when the shock absorber is set to
the standard setting.
_
1. Rebound damping force adjusting screw
2. Position indicator marks
Tightening torque:
Locknut:
45 Nm (4.5 m·kgf, 33 ft·lbf)
Minimum (soft): Adjusting screw fully turned
out
Standard: Adjusting screw 1 3/4 turns out
from the fully turned in position
Maximum (hard): Adjusting screw fully
turned in
U5TG10.book Page 21 Monday, April 7, 2003 8:50 PM