Filter
Top Products
8-22
4. Install the spark plug cap.
CAUTION:
_
Do not use any tools to remove or install
the spark plug cap, otherwise the ignition
coil coupler may be damaged. The spark
plug cap may be difficult to remove be-
cause the rubber seal on the end of the
cap fits tightly. To remove the spark plug
cap, simply twist it back and forth while
pulling it out; to install it, twist it back and
forth while pushing it in.
_
5. Place the fuel tank in the original position,
and then install the bolt.
6. Remove the fuel tank cap by turning it
counterclockwise.
7. Place the panel in the original position.
1. Projection (× 4) 2. Slot (× 4)
8. Install the fuel tank cap by turning it
clockwise.
9. Install the bolts and the quick fasteners.
NOTE:
_
To install the quick fastener, push the center
pin out so that it will protrude from the fastener
head, insert the fastener into the panel, and
then push the protruding pin in until it is flush
with the fastener head.
_
10. Install the seat.
U5TG10.book Page 22 Monday, April 7, 2003 8:50 PM