Filter
Top Products
INSTRUMENT AND CONTROL FUNCTIONS
4-7
4
EAUW0482
Seat
To remove the seat
1. Remove panel A. (See page 7-6.)
2. Remove the bolt.
3. Remove the bolt that fastens the
seat and panel C.
4. Remove the seat by pulling it off.
To install the seat
1. Insert the seat projections into the
seat holders as shown.
2. Place the seat in the original posi-
tion, and then tighten the bolts.
3. Install the panel.
TIP
Make sure that the seat is properly se-
cured before riding.
EAU14722
Adjusting the front fork
WARNING
EWA10180
Always adjust both fork legs equal-
ly, otherwise poor handling and loss
of stability may result.
This front fork is equipped with spring
preload adjusting bolts.
NOTICE
ECA10101
To avoid damaging the mechanism,
do not attempt to turn beyond the
maximum or minimum settings.
Adjust the spring preload as follows.
To increase the spring preload and
thereby harden the suspension, turn
the adjusting bolt on each fork leg in di-
rection (a). To decrease the spring pre-
load and thereby soften the
suspension, turn the adjusting bolt on
each fork leg in direction (b).
1. Bolt
2. Panel C
U39C12E0.book Page 7 Thursday, June 9, 2011 2:29 PM