Filter
Top Products
Maintenance
62
9. Dispose of used oil according to local
regulations.
NOTE:
● For more information on the disposal of
used oil, consult your Yamaha dealer.
● Change the oil more often when operating
the engine under adverse conditions such
as extended trolling.
Draining the oil by removing the oil drain
screw
1. Remove the four bolts to remove the
apron from the starboard side.
2. Tilt the outboard motor 5–10 degrees up,
then turn it entirely to the starboard side
until the drain screw is directly below.
3. Prepare a suitable container that holds a
larger amount than the engine oil capaci-
ty. Loosen and remove the drain screw
while holding the container under the
drain hole. Let the oil drain completely.
Wipe up any spilled oil immediately.
4. Put a new gasket on the oil drain screw.
Apply a light coat of oil to the gasket and
install the drain screw.
NOTE:
● If a torque wrench is not available when you
are installing the drain screw, finger tighten
the screw just until the gasket comes into
contact with the surface of the drain hole.
Then tighten 1/4 to 1/2 turn more. Tighten
the drain screw to the correct torque with a
torque wrench as soon as possible.
● Apply grease to the apron retaining bolts
before tightening them.
5. Add the engine oil and check the oil level.
Refer to steps 3 to 9 in the previous oil
changing procedure with the oil changer.
1. Oil dipstick
2. Lower level mark “”
3. Upper level mark “”
1. Drain screw
Drain screw tightening torque:
28.0 Nm (20.7 ft-lb) (2.86 kgf-m)
U69J17E0.book Page 62 Tuesday, March 7, 2006 10:00 AM