Filter
Top Products
Operation
46
2. Disconnect the fuel line from the out-
board motor or close the fuel cock.
3. Press the power trim and tilt switch / pow-
er tilt switch “” (up) until the outboard
motor has tilted up completely.
4. Push the tilt support knob into the clamp
bracket or pull the tilt support lever toward
you to support the engine.
WARNING
EWM00260
After tilting the outboard motor, be sure to
support it with the tilt support knob or tilt
support lever. Otherwise the outboard mo-
tor could fall back down suddenly if oil in
the power trim and tilt unit loses pressure.
5. Models equipped with trim rods: Once the
outboard motor is supported with the tilt
support lever, press the power trim and
tilt switch / power tilt switch “” (down) to
retract the trim rods.
N
ZMU04588
ZMU04602
UP
ZMU01886
U69J17E0.book Page 46 Tuesday, March 7, 2006 10:00 AM