Filter
Top Products
30
FCC Compliance
This device complies with Part 15 of the U.S. Federal Communications
Commission (FCC) Rules. Operation is subject to the following
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may cause
undesired operation.
Changes or modifications not expressly approved by the
manufacturer could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of he FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications. There is no guarantee that inter-
ference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following means:
1. Rotate or relocate the receiving antenna
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from
that which the receiver is connected.
4. Consult the manufacturer customer service department for help.
Under normal operating conditions, the antenna is designed to
maintain a separation distance of 20cm from all persons. The EUT is
mobile and fixed.