Filter
Top Products
22
Building your GPS Fence
To build your GPS Fence, you will need to set GPS fence posts that
will be used to outline the perimeter of you desired boundary. After
establishing these fence posts, RoamEO will automatically ‘draw’ in the
fence and store it in memory for future use.
1. Only one GPS Fence can be stored in memory at a time.
2. Each time a new GPS Fence is established, the current fence that
was stored in memory is deleted and replaced with your new fence
coordinates.
3. There is no method of correcting mistakes once RoamEO is placed
in the Fence Building mode. Should you discover that you have
misplaced a fence post, or do not like the shape of your fence, there
is no way to correct this data while in the Fence Building mode; it will
be necessary to start over. You will need to turn off your system and
power back up, and then begin the fence building process again.
Remember: turning off your system while in the Fence Building
mode will erase any fence posts you had placed for your new
fence, but it will not erase the last GPS Fence that was previous-
ly stored in memory.