Filter
Top Products
28
Enrolling Collars to your GPS Receiver
In order for RoamEO to operate, the Collar must be set up to be able
to ‘talk’ to a Receiver. Each RoamEO Collar contains a unique ID which
is used so that it only communicates with the Receiver which has
been programmed to recognize that ID. The process of ‘bonding’ a
specific collar (i.e., its unique ID) with a Receiver is called Enrollment.
Your collar(s) were enrolled at the factory and no further action is
needed to use RoamEO. However, if you purchase an additional
Collar, or replace an existing one, or would just like to change the color
choice assigned by the factory, you must use the Enrollment process.
There are four steps to the Enrollment process. You must have both
your Receiver and the Collar you wish to enroll to successfully
complete this process. Place the Collar within five feet of the Receiver.
Step 1
Press the and buttons on the GPS Receiver at the same
time. This will set the GPS Receiver into the Enrollment mode and
cause the Enrollment screen to be displayed See figure 13.
RoamEO can track three Collars, each of which is designated by a dif-
ferent color. Collars which are currently enrolled will be illuminated by
one of the three colors. Collars available for enrollment are shown in
gr
ay—these Collars have not been previously enrolled. RoamEO will
automatically select the first collar that has not been previously
enrolled.
Opt
ion
Collar Enrollment Screen
Figure 13