Filter
Top Products
TeleType GPS Manual17
© 2003 TeleType GPS
typical setup and connection procedures for your Bluetooth receiver (for help with connection, please
review the Connection section).
Once you have established a pairing, double-click on or tap the "TeleType: SPP Slave" icon to connect
your PDA to your Bluetooth receiver.
Finally, run the TeleType GPS software. Go to Tools > GPS Status > Status, select COM 8 as your
port, 4800bps, and tap Open Port. You should see symbols scrolling in the gray box below.
Q: When I have my Bluetooth GPS receiver plugged into the power adapter, I switch it on, and
nothing happens. The lights do not blink. However, when I switch it off, the lights are blinking.
What's happening?
In some receivers (not all), the "On" refers to whether or not you want to use the batteries as opposed
to the charger. Thus, if you wish to use the charger for your Bluetooth receiver, make sure the switch
is set to "Off".
1.5 Care and Maintenance
Your TeleType Bluetooth GPS Receiver should be treated with care and properly maintained to ensure
the best performance. Keep in mind these helpful tips when using your receiver:
·
Keep this and all accessories out of small children's reach.
·
Keep your Bluetooth GPS receiver dry. Do not expose to rain, water, or high humidity environments.
Humidity, liquids, and precipitation contain minerals that will corrode its connectors, jacks, plugs, and
electronic circuit boards.
·
Use only the supplied and approved accessories. Unauthorized accessories, antenna, modifications
or attachments could damage the Bluetooth GPS receiver, and may violate regulations governing
radio devices.
·
Only use the charger supplied for charging purposes. Use any other charger may damage the
Bluetooth GPS receiver and even run the risk of leaking batteries or explosion.
·
Use a dry, clean soft cloth to clean the unit. Do not use harsh cleaning solvents, chemicals, or strong
detergents.
·
Do not drop, shake, or knock the Bluetooth GPS receiver. Rough handling can break the connector,
jack, and internal electronic circuit boards. This will cause non-recoverable damages to the product.
·
Do not store the Bluetooth GPS receiver in dusty, dirty areas. Its moving parts, like connector pins
and clips, can be damaged.
·
Do not store the Bluetooth GPS receiver in hot area. High temperatures can shorten the life of
electronic devices, and melt or drape certain plastics.
·
Do not expose your TeleType Bluetooth GPS Receiver to temperatures higher than 158°F (70°C).
Do not leave your Bluetooth GPS receiver in your car under direct sunlight while not in use.
·
Do not store the Bluetooth GPS receiver in cold temperatures. When the unit warms up to its
normal operational temperature, moisture can aggregate inside it, severely damaging the electronic
circuit boards inside.
·
Do not attempt to open the Bluetooth GPS receiver. Unauthorized handling may damage the unit,
and void your warranty.