Filter
Top Products
Bluetooth GPS Receiver 12
© 2003 TeleType GPS
1.3.3 Using the Bluetooth GPS Receiver
Make sure that your TeleType Bluetooth GPS Receiver is connected to your host device.
1.
Run the TeleType GPS software.
2.
Make sure the appropriate
*_place.ttm
file for your country is loaded. Go to
File > Load > Load
maps
, find the directory your
*_place.ttm
file is located in, and load it. For example, if you were in
the US, you would load the US_place.ttm file.
3.
Go to
Tools > Find
. Select
Address
.
v092003
v122003
4.
Enter information for only the city and state, then select the appropriate country. Select Find. Pick
your city from the list and select
Go To
. On the following screen, select
GPS Initialization
.