Filter
Top Products
172-082010_400 I Series Software Page 26 of 35
item 12: softstart type:
item 13: softstart value:
item 14: trckg error:
item 15: trckg error:
item 16: trckg alarm limit:
item 17: trckg alarm limit:
item 18: trckg alarm enable:
item 19: trckg alarm delay:
item 20: trckg warn limit:
item 21: trckg warn limit:
item 22: trckg warn enable:
item 23: trckg warn delay:
item 27: valve drive:
item 28: valve set:
item 29: valve crackg:
item 30: valve shut:
item 31: valve lim:
2.7. Valve List by item number
item 1 :MFC mode:
read V1(cr) or *[aa]V1(cr)
Sample reply: 1(cr)>
write V1= 0(cr) or *[aa]V1= 0(cr)
This controls the operating mode of the valve control. See MFC Mode word in control
and status words section.
0: DEFAULT mode.
1: AUTO
2: HOLD
3: SHUT
4: PURGE
5: VARIABLE (or "manual")
item 2 :MFC config:
read V2(cr) or *[aa]V2(cr)
Sample reply: x0041(cr)>
write V1= 0(cr) or *[aa]V1= 0(cr)
This controls the source of the command signal. See MFC Configuration word in control
and status words section.
X0041 = Digital control
X0081 = Analog Control
The MFC Configuration word stores user settings that establish the features and behavior of the
flow controller, and is set by network command "V 2". It is user-writeable and nonvolatile.