Filter
Top Products
IMPREZA U.S.A. (E)
3
Instruments and controls
3-23
– CONTINUED –
“LOCK” position and clean the rear window to allow proper wiper
operation.
D To prevent the washer motor from overheating, avoid operat-
ing the washer switch for more than 10 seconds continuously, or
when the washer fluid tank is empty. Check washer fluid level fre-
quently, such as at fuel stops.
D Use clean water if windshield washer fluid is unavailabale. In
areas where water freezes in winter, use SUBARU Windshield
Washer Fluid or the equivalent. (See Windshield Washer Fluid
section in chapter 10.)
Also, when driving the vehicle when there are freezing tempera-
tures, use non-freezing type wiper blades.
HS0062
Wiper ON
& washer
Wiper ON
Washer
To turn the rear wiper on, turn the knob on the end of the wiper control
lever to the “ON” position.
To turn the wiper off, return the knob on the end of the lever to the “OFF”
position.
B Washer
To wash the rear window while the rear wiper is operating, turn the
knob on the end of the wiper control lever counterclockwise to the
“
” position. The washer fluid sprays until you release the knob.
To wash the rear window when the rear wiper is not in use, turn the
knob on the end of the wiper control lever clockwise to the “
”
position. The washer fluid sprays and the wiper operates until you re-
lease the knob.