Filter
Top Products
IMPREZA U.S.A. (E)
3
Instruments and controls
3-21
– CONTINUED –
D Clean your wiper blades and windshield periodically with a wind-
shield washer solution to prevent streaking, and to remove accumula-
tions of road salt or road film. Keep the windshield washer button
depressed at least for 1 second so that washer solution will be sprinkled
all over the windshield or rear window.
D Grease, wax, insects or other material on the windshield or the wiper
blade results in jerky wiper operation and streaking on the glass. If you
cannot remove those streaks after operating the windshield washer or if
the wiper operation is jerky, clean the outer surface of the windshield (or
rear window) and the wiper blades using a sponge or soft cloth with a
neutral detergent or mild-abrasive cleaner. After cleaning, rinse the wind-
shield and wiper blades with clean water. The windshield is clearn if
beads do not form when you rinse the windshield with water.
D If you cannot eliminate streaking even after following this method,
replace the wiper blades with new ones. Refer to the Wiper Blade
Replacement section (chapter 10) for replacement instructions.
J Windshield wipers and washer switch
B Windshield wipers
HS0060
OFF
INT
LO
HI
Mist
To turn the wipers on, push the wiper control lever down.
: Intermittent
LO : Low speed
HI : High speed