Filter
Top Products
14 ► CT06 User Manual
TOOL PROTECTION & CARE
• Make sure all couplers are wiped clean before con-
nection.
• The hydraulic circuit control valve must be in the
“OFF” position when coupling or uncoupling hy-
draulic tools. Failure to do so may result in damage
to the quick couplers and cause overheating of the
hydraulic system.
• Always store the tool in a clean dry space, safe from
damage or pilferage.
• Make sure the circuit PRESSURE hose (with male
quick disconnect) is connected to the “IN” port. The
circuit RETURN hose (with female quick discon-
nect) is connected to the opposite port. Do not re-
verse circuit ow. This can cause damage to internal
seals.
• Always replace hoses, couplings and other parts
with replacement parts recommended by Stanley
Hydraulic Tools. Supply hoses must have a mini-
mum working pressure rating of 2500 psi/172 bar.
NOTICE
In addition to the Safety Precautions found in
this manual, observe the following for equipment
protection and care.
• Do not exceed the rated ow. Refer to Specications
in this manual for correct ow rate. Rapid failure of
the internal seals may result.
• Always keep critical tool markings, such as warning
stickers and tags legible.
• Do not force a small tool to do the job of a large tool.
• Tool repair should be performed by experienced
personnel only.
• Make certain that the recommended relief valves
are installed in the pressure side of the system.
• Do not use the tool for applications for which it was
not intended.