Filter
Top Products
OPERATION
CT06 User Manual ◄ 13
7. Release the trigger to retract the nibs.
8. Repeat the crimp as required.
9. After the last crimp, make sure the nibs in the crimp-
ing head are fully retracted
10. Pull out the latch pin and rotate the latch away from
the crimping head.
11. Remove the tool by lifting it clear of the cable.
SHUTDOWN
1. Move the hydraulic system control valve to the OFF
position.
2. Disconnect the hydraulic hoses from the tool: rst
the input (supply) hose, then the output (return)
hose.
3. Insert plugs in the hose ends, couplers or tool ports,
as applicable.
4. Wipe the tool thoroughly with a clean dry cloth.
5. Clean any foreign matter or joint compound from the
die holder surfaces.
COLD WEATHER OPERATION
IMPORTANT
Use an oil with the recommended specication from
the HTMA Requirement table. Using oil that is too
viscous (thick) can damage the hydraulic system.
If the tools is to be used during cold weather, preheat the
hydraulic uid at low engine speed. When using the nor-
mally recommended uids, uid temperature should be
at or above 50°F/10°C (400 ssu/82 centistokes) before
use.
Damage to the hydraulic system or compression tool
can result from use with uid that is too viscous or too
thick.
STORAGE
Replace any damaged or missing safety labels and tags
before storing the tool. Clean, dry and lubricate moving
parts before storage. Store in a clean, dry place.