Filter
Top Products
41
Repeat the process anytime you need to change or
update a target.
Important: To use the Edit feature, you must be on
the course and the Sonocaddie should have good
satellite reception (six or more satellites).
Step 1: Select “MORE” with the right soft key and
then select “EDIT” to view the Edit Screen.
Step 2: Stand at the target on the course that you
want to correct or update. Using the 5-way key,
scroll to and highlight the specific target icon on the
Edit Screen that you are correcting or updating.
Note the target distance reading may disappear
when you are standing within 5 yards of the target.
Step 3: Press “SELECT” with the right soft key to
access the “Target Icon” screen. Scroll to the icon
you want to record for that hole (refer back to
Chapter 4.3 for icon definitions). If you are
correcting a distance reading, select the same icon
that you selected previously on the Edit Screen. If
you are changing the target, select a new icon which
is more appropriate.
Important: Before pressing “Record”, be sure you
stand still for five seconds at the target location so
the Sonocaddie can pin-point that position. After