Filter
Top Products
34
4. Bring the end of the cable out at the PowerConnect Vehicle Dock
location. Leave yourself enough cable so you can easily connect it
to the antenna connector of the dock.
5. Continue with “Step 5: Connect the Magnetic Mount Antenna and
PowerConnect Power Adapter” on page 37.
•Convertible:
1. Bring the antenna cable from the antenna into the trunk at the front
edge of the trunk lid. Keep any bends in the cable loose. Tape or
tie the cable along the inside of the trunk lid to the trunk lid hinge
strut.
2. Allow enough slack in the cable so the trunk lid and convertible roof
can easily open and close and keep the cable away from hinges,
gears, etc., that could crimp or cut it. Route the cable along the
trunk wall and into the cabin through a conduit or along an existing
wiring harness.
3. Route the cable through the main cabin area under the interior trim,
towards the front of the vehicle.
Use a blunt plastic putty knife
or similar blunt tool to lift the
plastic trim just enough to tuck
the cable under underneath.
Avoid side airbag locations on
back pillars and above the doors.
Airbag locations are marked
with “SRS” logos. Be careful not
to crimp or cut the cable.
Vehicle Installation