Filter
Top Products
ST2C Starmate Replay User and Installation Guide
33
Note: Depending upon where in a particular
broadcast the channel was selected, the start
of a song or program may not be available in
memory. If this occurs, the playback will start
from where the audio began to be stored.
Pressing and holding the Rewind button for
one second rewinds playback in 10 second
intervals, which increase to 15 and then 30
second intervals the longer the Rewind button
remains pressed. Playback begins
immediately when the button is released. If
the beginning of the stored audio is reached
while rewinding, a beep will be heard and
playback will automatically begin.
Using Instant Replay
To begin using the Instant Replay feature of the
Receiver, press the Pause/Play button. This
causes the Receiver to enter the Instant Replay
pause mode, which mutes the audio from the
Receiver. A “Paused” message will be displayed
for two seconds to confirm that the Receiver has
entered the Instant Replay mode.
001 Ch. Name
Artist NameArtist Name
Song TitleSong Title
Paused
-00:00:03
To listen to the audio that was stored, press the
Play/Pause button again and the Receiver will
begin to play back the audio stored in the Instant
Replay memory from the point where you
pressed the Play/Pause button.
As you are listening to the playback of the stored
audio, you may either fast forward or rewind
through the stored audio by pressing the fast-
forward or rewind buttons, without having to
press the Play/Pause button first. Refer to the
previous sections describing the Rewind and
Fast-Forward buttons for specific instructions for
their use.
Note: If the Receiver is tuned to another channel while
in the Instant Replay mode, the Instant Replay mode is
exited, all the audio stored in the Instant Replay
memory is erased, and the tuned channel begins to
play. Also note that tuning to another channel may
automatically occur if another feature of the Receiver
has been programmed to do so.