Filter
Top Products
10
English
● How to stop the regular alarm
The regular alarm rings at the designated time for 20 seconds
and stops. While the alarm is ringing, the regular alarm mark
flashes. To stop them manually, press button , ,
, or in any display.
● Alarm test
Press and hold buttons and at the same time in
the REGULAR ALARM or TIME/CALENDAR display.
C
D
Notes:
1. While you are underwater, the regular alarm rings for 3 seconds
and stops, but the regular alarm mark flashes for up to 20
seconds.
2. In testing the alarm, if button C is pressed just before pressing
button D, the engagement/disengagement of the regular alarm
and hourly time signal will be made. Show the REGULAR
ALARM display to engage or disengage them as required,
following the procedure above.
D
Press in the displays other than DIVE PLAN and
DIVE LOG to turn on the illuminating light.
D
• The display panel
is evenly
illuminated for 2
to 3 seconds.
Notes:
1. While the illuminating light is used, the watch may make a very
small noise. However, this is not a malfunction.
2. The electroluminescent panel loses its luminance as the battery
voltage becomes lower. Also, its luminance level decreases
gradually with use.
3. When the illuminating light becomes dim, replace the battery
with a new one. If the light remains dim after the battery is
replaced, have the electroluminescent panel replaced with a
new one by the retailer from whom the watch was purchased.
It will be replaced at cost.
B
A
C
D
■ ILLUMINATING LIGHT
HOW TO USE TIME FUNCTIONS