Filter
Top Products
2. Set the driver’s and passenger’s temperature.
To find your comfort setting, start with a 73°F
(22.5°C) temperature setting and allow
about 20 minutes for the system to regulate.
Use the driver’s or passenger’s temperature
buttons to adjust the temperature setting
as necessary. If you choose the temperature
setting of 60°F (15°C), the system remains
at the maximum cooling setting. If you choose
the temperature setting of 90°F (32°C), the
system remains at the maximum heat setting.
Choosing either maximum setting will not
cause the vehicle to heat or cool any faster.
Do not cover the solar sensor located on the top
of the instrument panel near the windshield.
This sensor regulates air temperature based on
sun load and also turns on your vehicle’s
headlamps. For more information on the solar
sensor, see “Sensors” later in this section.
To avoid blowing cold air in cold weather, the
system delays turning on the fan until warm air is
available. The length of delay depends on the
engine coolant temperature. Press the fan switch
to override this delay and change the fan to a
selected speed.
O (On/Off): Press this button to turn off the
climate control system. Outside air still enters the
vehicle, and is directed to the floor. This
direction can be changed by pressing the mode
button. Recirculation can only be selected in
vent or bi-level mode. The temperature can also
be adjusted using either temperature button. If you
adjust the air delivery mode or temperature
settings with the system off, the display comes on
briefly to show the settings and then turns off.
Press the on/off button or the up down arrows on
the fan switch, the defrost button, AUTO button,
or the air conditioning button to turn the system on
when it is off.
200