Filter
Top Products
Power Lumbar
If the seats have power lumbar, the controls used
to operate this feature are located on the
outboard side of the seats. See Power Seats on
page 10 for more information.
• To increase lumbar support, press and hold
the front of the control.
• To decrease lumbar support, press and hold
the rear of the control.
• To raise the height of the lumbar support,
press and hold the top of the control.
• To lower the height of the lumbar support,
press and hold the bottom of the control.
Release the control when the lower seatback
reaches the desired level of lumbar support.
Keep in mind that as your seating position
changes, as it may during long trips, so should the
position of your lumbar support. Adjust the seat
as needed.
Heated Seats
On vehicles with heated front seats the controls
are located on the center console near the climate
controls. To operate the heated seats the
ignition must be on.
I(Heated Seatback): Press this button to turn
on the heated seatback.
J(Heated Seat and Seatback): Press this
button to turn on the heated seat and seatback.
The light on the button will come on to indicate that
the feature is working. Press the button to cycle
through the temperature settings of high, medium,
and low and to turn the heat to the seat off.
Indicator lights above the button will show the level
of heat selected: three for high, two for medium,
and one for low.
The heated seats will turn off ten seconds after
the ignition is turned off. If you want to use
the heated seat feature after you restart your
vehicle, you will need to press the heated seat or
seatback button again.
12